Insta360 Insta360 Floating Surfboard Mount Compatible with X4X3X2 GO 3S32 ACE PROACEONE RS Gopro Hero 13121110 9Max AKASO EK7000Brave 4Brave 7 LEBrave 7

The Sticky Base is highly adhesive and may be difficult to remove from the surfboard. It cannot be reapplied after being removed. Do not remove it after surfing; simply leave it on the board. If you wish to remove the Sticky Base, use a hair dryer to soften the adhesive and peel it away from the edge of the base. Do not use sharp objects to remove it to avoid damaging your surfboard. When shooting with GO 3/GO 3S, install it onto the Floating Surfboard Mount with the GO 3/GO 3S Vertical & Horizontal Action Mount Set. Do not use the GO 3/GO 3S Quick Release Mount, or the camera may fall off. Do not install GO 3/GO 3S with the Action Pod, as it may affect the waterproofing. Install the GO 3/GO 3S Dive Case first if you use the Action Pod. The GO 3/GO 3S Vertical & Horizontal Action Mount Set and Dive Case are not included in the box, and they can be purchased separately. Store the Floating Surfboard Mount in temperatures between 50F to 140F (-10C to 60C) with humidity less than 90%. Avoid overexposure to the sun, as this may weaken the adhesiveness. Selfie sticks are not compatible with this mount as they may cause the camera to fall off. The Tri-Float can prevent your camera from sinking. If it falls off, the mount will float on the sea or wash ashore with your camera attached. If the Silicone Mount or Tri-Float are washed off, reattach them to continue using. When surfing but not using the camera, remove the Silicone Mount from the Sticky Base or insert a Thumb Screw onto the Silicone Mount to prevent it from falling off. It is not recommended for use with the Insta360 X3 or X4 Utility Frame. To enhance camera stability, use the X4 Vertical-Horizontal Mount with the Floating Surfboard Mount and mount X4 horizontally to lower the center of gravity. You can also use the Quick Release Mount to quickly switch between horizontal and vertical mounting.